 |
Inspiration |
|
|
|
|
|
|
Information |
|
|
|
|
|
|
 |
Home >
Products >
Forming Machines >
Power Hammers >
> Air Power Hammers >
Dies >
Standard Dies
|
|
| |
|
|
TM Standard Air Hammer Dies
|
|
|
We designed these dies based on 20 years of experience with this Air Hammer. We make these dies ourselves from high quality steel which is precision machined, hardened properly, tempered, and in some cases precision ground, for a perfect face or contact area. Every die we sell is U.S. industry-standard quality, is tested in our own shop, and is tried-and-true — guaranteed.
|
|
Zoom
|
Basic Die Set
This set includes high crown, low crown and flat dies for roughing, stretching and planishing. These are hardened steel with the
medium and flat die are precision ground to give small flat contact spots for smoother work. Can be used in conjunction with the roughing head, rubber head, small or large upper planishing dies. 1-5/8" diameter.
|
|
|
Zoom
|
Lower Die Large Flat
This 2" die is for planishing flat panels or raising gentle crowns. This die has a large flat contact area that is
precision ground onto its working surface. This would be the die for working gentle crowns in large skins (like the hood, door and roof
skins) used in conjunction with the large or small Upper Planishers.
|
|
|
Zoom
|
Large Upper Planisher
This is a 2.5" diameter flat-faced, hardened steel die that has been precision ground for flatness. This die is good for planishing as well as stretching many crowns and flat surfaces. You can use this for making door, hood and roof skins, or any large panels needing a low crown. This die is also one of your two main choices for planishing.
|
|
|
Zoom
|
Plastic Planishing Set
This 3-piece set contains low, med, and high crowned dies for smoothing soft metals without stretching. The special
black plastic enables the large or small Upper Planishers to planish .050 3003 (for example) to a beautiful, fine finish. 1-5/8" diameter.
|
|
|
Zoom
|
Small Upper Planisher
This die is 1.6" diameter and is hardened and precision ground to have a flat working face. It is used for working into corners, and into tight spots where the large planisher will not fit. It also curves flanges when used in conjunction with the lower Flange Curving Die. This die will not be good for large skins, but it will be one of your two main choices for planishing.
|
|
|
|
| |
|
|
|
|
