Our Spring Steel Slapper is constructed from 5160 heat treated spring steel and has a balance that allows it to actually rebound off the dolly for effortless use.
Use it to shrink, contour, and planish (smooth) the panel without leaving rough marks to clean up.
The slapper controls more surface with each blow than any hammer can and is very easy to use because it has the same angle of attack as your body hammer. This means you don't have to change your arm and hand position when moving from hammer to slapper. The slapper can be far more effective than the hammer for shrinking because its leverage gives greater mechanical advantage over the rough spots.
Unconditional guarantee: If this tool breaks in normal hard use it will be replaced free. Not one has ever broken!
Its Many Uses: Use the toe to pick up low spots and use the edge in reverse contours. Large high spots can be moved by holding the slapper against the spot and striking it with a hammer. It continues the cold shrink when used with the small forming bag and is ideal for planishing, fine tuning, and straightening.
This slapper is a hybrid design based on the very best features of all the slappers Kent has ever used and has been shop tested for over 15 years.
- More Photos Coming Soon -
Be the first person to write a review on this product.
TM Technologies takes pride in knowing we offer the best products on the market for metal working. In an effort to continue this tradition we are constantly improving our products and our product line. If you have any comments or suggestions, about this, or any of our other products we want to hear from you.
